Electrolux FAC124P1A Provozní pokyny Strana 45

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 140
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 44
Section 2 Installation
2-15
10. Clamp plastic window panel between a board and a
work table, and cut along cutting line with a fine
tooth saw. Remove any burrs with a file.
11. Fasten side channels to the sides of the AC using 3
screws (Item 17) per channel. Start with first screw
at top of channel. Make sure hook ends of channels
face toward back of unit.
12. Slide plastic window panel into panel frame, with the
smooth side to the room. Slide panel frame
assembly into side channels of the AC cabinet. Make
sure plastic window panel is firmly enclosed on all
sides by the retainer grooves. (See Figure 2-43)
13. Cut side channel seal into 2 equal lengths. Remove
protective backing and apply it to the rear side of
cabinet side channels starting just below panel frame
assembly. Pinch off excess length so seal is even
with the bottom of the cabinet side channel.
(See Figure 2-44)
14. To remove front:
a. Remove the two front retaining screws from the
front frame. (See Figure 2-45)
b. Press firmly on each side of the metal case close
to the front, approximately 2/3 of the way down.
c. While pressing on the sides of the metal case,
gently pull the front out and lift up to release it
from the case.
d. Then release the electrical coupler plug.
15. Place AC in window opening. The unit should sit on
the platform assembly so that window panel frame
and cabinet side channels are against top and side
window jambs.
16. Slide inner window sash firmly against side of the
cabinet. Make sure not to peel the seal strips from
the window track and cabinet side channels. If the
panel frame does not fit snugly to the inner window
sash, secure the panel frame to the sash with
#8 x 3/4 inch screws, or #8-32 x 3/4 inch self-
threading screws. Use the partially plugged holes in
the panel frame. Drill 1/8-inch pilot holes for the
screws. (See Figure 2-46)
DO NOT push or pull air direction louvers.
NOTE
Panel Frame
Plastic Window Panel
Fastening
Side Channels
Figure 2-43.
Apply Weather
Seal To Side
Channels Just
Below Edge Of
Panel Frame.
Front
Retaining
Screw
Figure 2-44.
Figure 2-45.
Slide Inner
Window Sash
Firmly Against
Cabinet.
Figure 2-46.
Zobrazit stránku 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 139 140

Komentáře k této Příručce

Žádné komentáře