Electrolux FAC124P1A Provozní pokyny stáhnout pdf (Strana 38)

Section 2 Installation

2-8

Extend Window Filler Panels

1. Carefully raise window to expose filler panel locking

screws. Loosen screws so filler panels slide easily.

2. Extend panels to completely fill window opening.

Tighten locking screws on top. (See Figure 2-26)

3. Close window behind top angle.

Install Window Lock and Sash Seal

1. Trim sash seal to fit window width. Insert into space

between upper and lower sashes.

2. Attach right angle safety lock as shown. (See Figure

2-27)

Install Chassis into Cabinet and Install Front to

Unit

1. Lift air conditioner and carefully slide into cabinet

leaving 6” protruding.

2. Be sure chassis is firmly seated towards rear of

cabinet.

3. Installation of front is the reverse of removal.

Locking Screws

Safety Lock

3/4" Long Hex-

Head Screw

Figure 2-26.

Figure 2-27.

Figure 2-28.

DO NOT push on controls or finned coils.

CAUTION

Thru-The-Wall Installation

Select Wall Location

Consult local building codes prior to installation.

This air conditioner has a slide-out chassis, so that it can

be installed through an outside wall as speciﬁ ed below:

Heavy Duty (FAS) Median (FAM)

Max wall thickness: 12” 10”

All parts needed for Thru-The-Wall Installation are

provided, except a wood frame, shims, and 10 wood

screws (#10-1” long minimum).

Select a wall surface that has the 5 conditions below:

1. Does not support major structural loads such as the

frame.

2. Does not have plumbing or wiring inside.

3. Is near existing electrical outlets, or where another

outlet can be installed.

4. Is not blocked and faces the area to be cooled.

5. Allows unblocked airflow from rear sides and end

(outside).

Prepare Wall

1. Prepare wall in frame construction (including brick

and stucco veneer). Working from inside the room,

find wall stud nearest the center of area where air

conditioner will be installed (by sounding wall, or by

magnetically finding nails).

2. Cut or knock out a hole on each side of center stud.

3. Measure between inside edges of every other stud

as shown. (See Figure 2-28)

Side louvers must never be blocked.

IMPORTANT

3-3/8" Min

(8.6 cm)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 139 140

Komentáře k této Příručce

Žádné komentáře

Electrolux FAC124P1A Provozní pokyny Strana 38

Komentáře k této Příručce

Související produkty a manuály pro Split-systém klimatizace Electrolux FAC124P1A