Electrolux GHL346SW Instalační manuál stáhnout pdf (Strana 6)

2. Fix the oven with 2 screws at every

side.

A

3. Open the door to access the gas

installation.

4. Connect the oven to the gas supply.

1.12 Installing burners

1. Remove the screws (1) and (3) from

the transport safeguards on the left

and right side (2) and remove the

transport safeguards.

2. Loosen the four screws (4) next to

the four burners.

1

2

4

3

3

1

2

3

3

CAUTION!

The screws to secure

the horizontal support

are necessary when the

hob is installed with a

wooden surround frame.

3. If necessary, loosen the eight screws

(5) on the two cross bars and lift the

cross bars up. Tighten the screws

again firmly.

5

5

4. Lift the burner unit to the height of the

worktop. Burners on upper corner of

the cooking zones should achieve

the height of the worktop.

5. Slide the unit along the worktop.

Fasten the unit in the cut-out using

the six screws (6) provided. Use

three screws at each side.

66

• In case of a 490 mm deep cut-out,

move the unit forward along the

worktop until it stops.

• In case of a 504 mm cut-out, push

the unit to the end and then move

it back towards yourself by 7 mm.

6. Put the hob back on the cooking

surface and adjust the burners. Make

sure that the hob does not rise above

the surrounding worktop surfaces.

www.electrolux.com6

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře