Electrolux END32320X Uživatelský manuál stáhnout pdf (Strana 8)

8 electrolux

Before plugging-in and adjusting your

appliance, leave it approximately 3 hours on

stand-by, in a vertical position, or for 5 hours

if it was transported on its side.

On commissioning

Your appliance is designed for storing food,

so take care to clean the interior with warm

water and odourless detergent (washing-up

liquid) before use. Rinse and dry thoroughly.

If you unplug or turn off the appliance, wait

at least 10 minutes before plugging it back in

or turning it back on to avoid damaging the

compressor.

Your appliance is ventilated, which is why it is

normal, during operation, to hear the noise of

circulating air generated by the appliance fan.

Thermostats

Freezer compartment

The temperature inside each compartment

is adjusted using a thermostat graduated

from a minimum position up to a maximum

“COLDER” position, where the “COLDER”

position is the coldest temperature.

Since the “minimum position” and “COLDER”

settings are extremes, we advise you to

make the initial commissioning adjustment

to a setting in between, taking into account

the following comments: subsequently, your

experience alone will allow you to decide

which is the best setting.

Refrigerator compartment

On commissioning or after an extended

period of appliance downtime and if you

wish to use the freezer compartment, set

the freezer compartment thermostat to the

“COLDER” setting for approximately 2 hours

before putting any frozen or deep-frozen

foods inside the freezer compartment.

Then set the thermostat back to a normal

operating setting.

Notes:

The temperature inside the compartments

depends on several factors, such as the

ambient temperature, the quantity of food

stored, the frequency with which the door is

opened, etc.

Refrigerator compartment

Temperature indicator

To assist you in setting your appliance

correctly, we have ﬁtted your refrigerator with

a temperature indicator, which is located in

the coldest zone.

For the proper preservation of the food

inside your refrigerator, and in particular in

the coldest zone, make sure the temperature

indicator displays “OK”.

If “OK” is not displayed, the average

temperature of the zone is too high. Adjust

the thermostat to a higher setting.

Since the word “OK” appears in black, it is

difﬁcult to see if the temperature indicator

is not lit properly. It is easier to read if it is lit

correctly.

Every time the thermostat setting is changed,

wait for the temperature inside the appliance

to stabilise before changing to another

setting, if necessary. Only change the

thermostat setting progressively and wait at

least 12 hours before running another check

and making another change if necessary.

N.B. : Once you have loaded all your fresh

food into the refrigerator or after the door

has been opened repeatedly (or left open

for an extended period of time), it is normal

that the word “OK” does not appear in the

Use

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Komentáře k této Příručce

Žádné komentáře