Electrolux EVE8P21X Uživatelský manuál stáhnout pdf (Strana 37)

Normal 1 h 30 min

for a usual

degree of dirt

Intense 2 h 30 min

for a high de‐

gree of dirt

4. Press to confirm.

When the pyrolytic cleaning

starts, the oven door is

locked and the lamp does

not work.

To stop the pyrolytic

cleaning before it is

completed, turn off the oven.

WARNING!

After the function is

completed, the oven is very

hot. Let it cool down. There

is a risk of burns.

After the function is

completed, the door stays

locked for the cool down

phase. Some of the oven

functions are not available

during the cool down phase.

12.4 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A)

on the two door hinges.

A

A

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the oven at

an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

6. Hold the door trim (B) on the top

edge of the door at the two sides and

push inwards to release the clip seal.

1

2

B

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger and the door.

WARNING!

Make sure that the glasses

are inserted in the correct

position otherwise the

surface of the door may

overheat.

12.5 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

ENGLISH 37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Komentáře k této Příručce

Žádné komentáře