Electrolux EASX24C5ATLW Uživatelský manuál stáhnout pdf (Strana 14)

Fixing the installation plate

Drilling the Hole

1. Install the installation plate

horizontally over the structural

parts on the wall using the spaces

indicated on the plate, as shown in

the figure above.

2. In the case of tiled, concrete or

similar walls, create 5 mm-

diameter holes. Place anchorage

supports for the appropriate

assembly screws.

3. If expansion screws are used, the

holes must measure 11x20 or

11x26, with a distance of 450 mm

between each.

4. Fix the installation plate to the wall.

1. Determine the position of the hole

for the pipe using the installation

plate and drill the pipe hole (ø

65mm) so that it is titled slightly

downward.

2. Always use a pipe cover with an

opening when drilling a metal bar.

Installation plate

Fit the Installation Plate and drill holes

in the wall according to the wall

structure and corresponding mounting

points on the installation plate

(Dimensions are in “mm” unless

otherwise stated).

Wall

Indoor unit

Outdoor unit

5-7mm

13 electrolux indoor unit installation

24k Btu models

A type

24k Btu models

B type

how the air conditioner works electrolux 42

TIMER Operation

TIMER button can set the auto-on time of the unit.

To set the starting time

1. Push the TIMER ON button, then the remote controller shows TIMER ON ,

the last set time for the starting operation and the signal "h" will be shown on

the DIGITAL DISPLAY area. You are now ready to reset the time to START the

operation.

2. Push the TIMER ON button again to set desired unit start time.

3. After setting the TIMER ON ,there will be a one-half second delay before the

remote controller transmits the signal to the air conditioner. Then, after

approximately another 2 seconds, the signal "h" disappears and the set

temperature will re-appear on the digital display.

To set the stopping time

1. Push the TIMER OFF button and the remote controller will show TIMER OFF,

the last set time for the stopping operation and the signal "h" will be shown

on the DIGITAL DISPLAY area. You are now ready to reset the time of the

STOP operation.

2. Push the TIMER OFF button again to set the time you want to stop the

operation.

3. After setting the TIMER OFF ,there will be a one-half second delay before

the remote controller transmits the signal to the air conditioner. Then, after

approximately another 2 seconds, the signal "h" disappears and the set

temperature will re-appear on the digital display.

Exemples:

(Temp On)

OFF

(Temp Off)

OFF

12h

(Temp Off)

OFF

14h

(Temp On)

20h

(Temp On)

ONN

OFF

23h

(Temp Off)

OFF

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Electrolux EASX24C5ATLW Uživatelský manuál Strana 14

Komentáře k této Příručce

Související produkty a manuály pro Split-systém klimatizace Electrolux EASX24C5ATLW