
Removing and cleaning the door
glasses
1. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2
B
1
2. Pull the door trim to the front to remove
it.
3. Hold the door glass panels on their top
edge one by one and pull them up-
wards out of the guide
4. Clean the door glass panels.
To install panels follow the procedure in
reverse. Insert the smaller panel first,
then the larger.
OVEN LAMP
Warning! There is a danger of
electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.
Replacing the oven lamp
1. You can find the lamp glass cover at
the back of the cavity.
Turn the lamp glass cover counter-
clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with applicable
300°C heat-resistant oven lamp.
Important! Use the same oven lamp type.
4. Install the glass cover.
REMOVING THE DRAWER
The drawer underneath the oven can be re-
moved for easier cleaning.
Removing the drawer
1. Pull the drawer out as far as possible.
2. Lift the drawer slightly, so that can be
lifted upwards at an angle of the drawer
guides.
Inserting the drawer
To instal the drawer follow the procedure in
reverse
Warning! When the oven is in use,
heat can build up in the drawer. For
this reason, do not keep flammable
things in there such as e.g. cleaning
materials, plastic bags, oven gloves,
paper, cleaning sprays, etc.
WHAT TO DO IF…
Warning! Refer to "Safety information"
chapter.
Problem Possible cause Remedy
The residual heat indicators
does not come on
The cooking zone is not hot
because it operated only for a
short time
If the cooking zone must be
hot, speak to the after sales
service
The appliance does not operate The fuse in the fuse box is re-
leased
Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
20 electrolux
Komentáře k této Příručce