
Problem Possible cause Solution
The temperature in the
appliance is too high.
Contact a qualified electri‐
cian or contact the nearest
Authorized Service Centre.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the
lamp".
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to "Operation" chapter.
Many products were put
in at the same time.
Wait some hours and then
check the temperature
again.
The room temperature is
too high.
Refer to climate class chart
on the rating plate.
Products placed in the
appliance were too
warm.
Allow products to cool to
room temperature before
storing.
The door is not closed
correctly.
Refer to "Closing the door".
Water flows on the rear
plate of the refrigerator.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the
wine cellar.
The water outlet is clog‐
ged.
Clean the water outlet.
Products prevent that
water flows into the water
collector.
Make sure that products do
not touch the rear plate.
DEMO appears on the dis‐
play.
The appliance is in dem‐
onstration mode.
Keep the Light pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
6.3 Replacing the lamp Wine
Cellar
1. Disconnect the mains plug from the
mains socket.
2. Remove the lamp cover by pressing
it inwards with a tool (e.g.
screwdriver) to free the rear side
hookings.
ENGLISH 11
Komentáře k této Příručce