Electrolux OOP601NX Uživatelský manuál stáhnout pdf (Strana 34)

5. Hold the door trim (B) on the top

edge of the door at the two sides and

push inwards to release the clip seal.

1

2

B

6. Pull the door trim to the front to

remove it.

7. Hold the door glass panels by their

top edge and carefully pull them out

one by one. Start from the top panel.

Make sure the glass slides out of the

supports completely.

8. Clean the glass panels with water

and soap. Dry the glass panels

carefully.

When the cleaning is completed, install

the glass panels and the oven door. Do

the above steps in the opposite

sequence.

Make sure that you put the glass panels

(A and B) back in the correct sequence.

The middle panel (B) has a decorative

frame. The screen-printing zone must

face the inner side of the door. Make

sure that after the installation the surface

of the glass panel frame (B) on the

screen-printing zones is not rough when

you touch it.

A B

Make sure that you install the middle

panel of glass in the seats correctly.

A

B

11.8 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

Wait until the oven is cooled down.

2. Disconnect the oven from the mains.

3. Put a cloth on the bottom of the

cavity.

CAUTION!

Always hold the halogen

lamp with a cloth to prevent

grease residue from burning

on the lamp.

The back lamp

1. Turn the lamp glass cover to remove

it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

www.electrolux.com34

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Komentáře k této Příručce

Žádné komentáře