Electrolux WOK38TSIO Uživatelský manuál stáhnout pdf (Strana 19)

8.8 Installation of more than one

hob

Supplied accessories: connection bar,

heat-resistant silicone, rubber shape,

sealing stripe.

Use only a special heat-

resistant silicone.

The worktop cutout

Distance

from the

wall

minimum 50 mm

Depth 490 mm

Width sum of all widths of hobs

that you install minus 20 mm

Example:

580 mm

520 mm

490 mm

360 mm

+ - =

20 mm 920 mm

Assembly

1. Calculate correct cutout dimensions.

2. Prepare cutout in the worktop.

3. One by one place the hobs on a soft

surface (for example on a blanket) with

the bottom side up.

4. Attach the supplied seal stripe to the

lower edge of the hob along the outer

edge of the glass ceramic.

5. Loosely screw the fixing plates into the

correct holes in the protective casing.

6. Insert first hob into the worktop

cutout. Than insert the connection bar

into the worktop cutout. Push it half of

its width under the hob.

7. Loosely screw in the fixing plates from

below to the worktop and to the

connection bar.

8. Insert next hob into the worktop

cutout. Make sure that the front edges

of the hobs are on the same level.

9. Tighten the fixing plates / retaining grip

screws.

10. Use silicone to seal the gaps between

the hobs and between the hobs and

the worktop.

11. Put some soapy water on the silicone.

12. Press the rubber shape with some

strength against the glass ceramic and

move it slowly along the space.

13. Do not touch the silicone until it

becomes hard, it can last about a day.

14. Carefully remove the silicone that

came out with a shaving blade.

15. Clean the glass surface.

ENGLISH

19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře