Electrolux ERCE9020AS Uživatelský manuál stáhnout pdf (Strana 5)

electrolux e:line rangehoodsdimensions/electricalconnection4

Dimensions

Canopy dimensions

NOTE: *The fan housing exhaust outlet is 163mm in diameter. Use

duct transition or ﬂexible pipe supplied with the canopy rangehood

as a reducer if using 150mm optional ducting accessories.

(See page 9 for optional ducting accessories).

ERCM9010AS

ERCE9020AS

ERCG9030AS

• Checkthatthemainsvoltagematcheswiththevoltage

on the data plate inside the canopy rangehood.

• Checkthattheinstallationcomplieswithstandardsof

local gas and electricity authorities.

• Ifthesupplycordisdamaged,itmustbereplacedby

the manufacturer or its service agent of similarly qualiﬁed

person in order to avoid a hazard.

Safety warnings – For the installer

When installing the cooker hood, make sure you adhere

to the minimum and maximum distances from the cooker

hoodbasetothehobsurface(aspertableonrightpage5).

Exhaust duct installation:

The following rules must be strictly followed to obtain

optimal air extraction.

• Keepexhaustductshortandstraight

• Donotreducethesizeorrestrictexhaustduct.

• Keepbendsintheexhaustducttoaminimum.

• Whenusingexibleductalwaysinstallductwith

helix pulled taut to minimise pressure loss.

• Failuretoobservethesebasicinstructionswill

drastically reduce the performance and increase the

noise levels of the cooker hood.

Exhaust air must not be discharged into a wall cavity, unless

the cavity is designed for that purpose.

The exhaust from the cooker hood must not be discharged

into any heating ﬂue, which may carry combustion products

from other sources.

Electrical connection

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Electrolux ERCE9020AS Uživatelský manuál Strana 5