Electrolux EHH9967FOZ Uživatelský manuál stáhnout pdf (Strana 10)

Refer to “Technical

information” chapter.

To activate the function for a cooking

zone: touch . comes on.

To deactivate the function: change the

heat setting.

4.8 Chef function

This function activates all cooking zones

and automatically activates for all of them

the Bridge function. The function sets the

same heat setting as the one you set the

last time.

For the first activation the heat setting of

the left pair of zones is set to

, the

middle pair is set to and the right pair

is set to .

To activate the function: touch . The

indicator comes on. All cooking zones

operate for 9 minutes. If the cooking

zones stay empty, the symbol comes

on. After 9 minutes an acoustic signal

sounds and the empty cooking zones are

set to .

To resume this function: touch to

put or move cookware on the deactivated

pair of cooking zones.

To deactivate this function:

• Touch

to deactivate the function for

the cooking zones you chose and keep

the last heat setting of the cooking

zones for this pair. The indicator goes

off.

• Set the heat setting to or let the

Count Down Timer deactivate the

cooking zones. The indicator goes off.

When the function is

deactivated, the pot

detection time is 2 minutes.

4.9 Timer

Count Down Timer

You can use this function to set how long

the cooking zone should operate for a

single cooking session.

First set the cooking zone then set the

function.The selection of the Timer

function is possible for cooking zones that

are active and after the heat setting is set.

To set the cooking zone: touch

again and again until the indicator of a

necessary cooking zone comes on. When

this function is active, comes on.

To activate the function: touch of

the timer to set the time (00 - 99 minutes).

When the indicator of the cooking zone

starts to flash slowly the time counts

down.

To see the remaining time: set the

cooking zone with

. The indicator of the

cooking zone starts to flash quickly. The

display shows the remaining time.

To change the time: set the cooking

zone with

. Touch or .

To deactivate the function: set the

cooking zone with and touch . The

remaining time counts back to 00. The

indicator of the cooking zone goes out.

When the time comes to an

end, the sound operates and

00 flashes. The cooking zone

deactivates.

To stop the sound: touch .

CountUp Timer (The count up

timer)

You can use this function to monitor how

long the cooking zone operates.

To set the cooking zone (if more than

1 cooking zone operates): touch

again and again until the indicator of a

necessary cooking zone comes on. When

this function is active, comes on.

To activate the function: touch . The

symbol goes out and comes on.

To see how long the cooking zone

operates: set the cooking zone with .

The indicator of the cooking zone starts to

flash quickly. The display shows how long

the zone operates. During the first minute

the display shows the time in seconds.

www.electrolux.com10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

Komentáře k této Příručce

Žádné komentáře