Electrolux EHT7833K Uživatelský manuál stáhnout pdf (Strana 33)

electrolux 33

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan

support.

To light a burner, turn the relevant knob

anticlockwise to maximum position

(

)and push down the knob to ignite.

After lighting the flame, keep the knob

pushed down for about 5 seconds. This

will allow the "thermocouple" to be heated

and the safety device to be switched off,

otherwise the gas supply would be

interrupted. Then, check the flame is

regular and adjust it as required. If you

cannot light the flame even after several

attempts, check the "cap" is in the correct

position.

If you cannot light the flame even after

several attempts, check the "cap" (lett.

A) and the "crown" (lett. B) are in the

correct position.

To put the flame out, turn the knob to the

symbol

In the absence of electricity, ignition

can occur without the electrical device;

in this case approach the burner with a

flame, push the relevant knob down

and turn it anti-clockwise until it reaches

the "maximum" position.

Operation

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

triple crown

burner

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Žádné komentáře

Electrolux EHT7833K Uživatelský manuál Strana 33