Electrolux ESL90600X Uživatelský manuál Strana 13

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 20
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 12
13
Use of detergent
Only use detergents specifically designed for use in
dishwashers.
Using no more than the correct amount of detergent
contributes to reducing pollution.
Please observe the manufacturers dosing and storage
recommendations as stated on the detergent packaging.
Fill with detergent
1. If the lid is closed: press release button (1). The lid springs
open.
2. Fill the detergent dispenser (2) with detergent.
The marking indicates the dosing levels:
20 = approximately 20 g of detergent
30 = approximately 30 g of detergent
3. All programmes with prewash need an additional detergent
dose (5/10 g) that must be placed in the prewash detergent
chamber (3). This detergent will take effect during the
prewash phase.
4. Close the lid and press until it locks in place.
Different kinds of detergent
Detergent tablets
Detergent tablets from different manufactures dissolve at
different rates. For this reason, some detergent tablets do not
attain their full cleaning power during short washing
programmes. Therefore, please use long washing programmes
when using detergent tablets, to ensure the complete removal
of detergent residuals.
Use of "3 in 1" combi detergents
These products are detergents with a combined cleaning,
rinsing and salt function.
1. Check whether these detergents are suitable for your water
hardness. Follow the manufacturers instructions.
2. Set the "3 in 1" function.
3. Before the start of the washing programme put the "3 in 1"
detergent in the detergent dispenser.
NOTE: If the drying results are not satisfactory we recommend
that you:
1. Fill up the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser and set the rinse aid
dosage to position 2.
If you decide to turn back to the use of the standard
detergent system we advise that you:
Deactivate the "3 in 1" function.
Fill up the dispensers for salt and rinse aid again.
Adjust the water hardness setting to the highest setting
and perform up to 3 normal washing programmes without
loading any dishes.
Adjust the water hardness setting according to the
hardness of the water in your area.
Adjust the rinse aid dosage.
NOTE: When using 4 in 1 detergents that integrate also anti-
glass corrosion agent into "3 in 1" formula, please follow the
same instruction as given for "3 in 1" detergents above.
Zobrazit stránku 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Komentáře k této Příručce

Žádné komentáře