5
3. Cleaning
Clean both the inside and outside of the
appliance before putting it into use.
To do so, use a soft towel, lukewarm water and a
non-abrasive detergent. Ensure water does not
enter the rear cover grille or the control elements.
Afterwards, wipe the appliance with a clean towel
and cleanwater, and then wipe it dry.
To avoid damage, do not use soap, soda or
abrasive cleaners.
4. Positioning the appliance
During the refrigeration process, the appliance
gives off heat from the condenser (under the
upper part of the rear cover) into the surrounding air.
The more ventilated the condenser is, the more
effective the refrigeration will be.
The other condition for satisfactory operation is that
the appliance stands on a flat surface. This is best
seen by placing a glass of water on top of the
appliance.
It is important that the appliance is not directly
exposed to radiated heat (sunlight, radiator, near an
oven, etc.).
In gas operation following clearances should be
kept from the walls or other materials: from the
back side of the appliance minimum 10cms, from
both sidewalls 4cms each, from the top of the
appliance minimum 30 cms, from the bottom
minimum 5cms.
In the immediate vicinity of the appliance within the
specified distances no inflammable matters (paper,
wood, grass, textile etc.) should be met with.
5. Using the appliance
The cable for mains connection, the 12V connecting
cable and the connector for the gas hook-up are
located on the right-hand side of the rear cover of the
cooling box, behind the door (Figure 2).
5.1. Operating from electrical mains
Make sure the voltage shown on the data plate of the
appliance matches that of the mains voltage to which
you wish to connect the appliance. After opening the
door, pull out the mains connecting cable and
connect it to a receptacle earthed socket for
connection.
When connecting the appliance for the first time, set
the thermostat to maximum; then, after about five
hours, set it back to a medium position. This is
suitable for general refrigeration requirements.
NB: Plug is provided according to specific
regulations in each country and may be different to
that shown.
Figure 2.
Komentáře k této Příručce