Electrolux EXS12HC2WI Uživatelský manuál

INSTALLATION MANUAL(Split Type)Please read this installation manual completelybefore installing the product.When the power cord is damaged, replacemen

BarCopper pipeClamp handleRed arrow markConeYokeHandleBar"A"C: Putting nut onRemove flare nuts attached to indoor andoutdoor unit, then put

ModelPower supplyInput Rated Amp(Switch/Fuse)9000Btu/hNOTE: The supply voltage should be consistent with the rated voltage of theair conditioner.Power

11After the confirmation of the above conditions, prepare the wiring as follows:1) Never fail to have an individual power circuit specifically for the

12Air purgingWhen relocate the unit to another place, perform evacuation using vacuum pump.For the R407C/R410A refrigerant models, make sure the refri

13Perform the electric safe check after completing installation:1. Insulated resistanceThe insulated resistance must be more than 2M .2. Grounding wor

14Test runningA: Lo packed valve B: Hi packed valveC and D are ends of indoor unit connection.CAUTIONIndoor unitcheck pointDBCAOutdoor unitcheck point

Installation manual

CONTENTSSAFETY PRECAUTIONS...2INSTALLATION OF INDOOR AND OUTDOOR UNITS...

2Safety precautions!WARNINGDo not install it yourself.Install the unit securely in a place whichcan bear the weight of the unit.Use the specified wire

INSTALLATION OF INDOOR AND OUTDOOR UNITS3Installation InstructionMore than 2.3mMore than 15cmMore than 12cmMore than 12cmMore than 60cmMore than 60cmM

1234567111881Parts youmustpurchaseNote: Except the above parts provided, the other parts needed during installation youmust purchase.CAUTIONInstall th

5Installation Instruction(Unit mm)Installation Dimension:12075045250Right refrigerantpipe hole 65Installation plateIndoor unit outlineLeft refrigerant

6Installation Instruction1. For the left-hand and right-hand piping, remove the pipe cover from the side panel.Explain to clients that the pipe cover

7Installation Instruction5. Piping and wrappingBundle the tubing, connecting cable, anddrain hose with tape securely,evenly as shown in Fig.10.Because

8Installation InstructionSettlement of outdoor unitAnchor the outdoor unit with a bolt and nut 10 or 8 tightly and horizontallyon a concrete or rigid