
8 9
Control operation
Lock – Press and hold ‘lock’ button for 3 seconds to
lock control interface when cleaning, press and hold for 3
seconds to unlock control interface.
The lock LED indicator will turn off after 3 minutes. If
a function button is pressed after lock LED indicator
has turned off there will be a “beep” and the Lock LED
indicator will ash for 5 seconds as a reminder that the
lock function is still active.
Speed 1 – suitable for light frying and light barbecuing
Speed 2 – suitable for frying, wok cooking and
barbecuing
Speed 3 – suitable for intensive frying, intensive wok
cooking and barbecuing
Speed 4 – suitable for very smoky cooking and/ or to
clear smoke from an area that has a build up
of smoke
WARNING!
The rangehood is not intended for continuous
use over barbecues with lit burners, without
cooking in progress
Timer off – At the end of cooking if the timer is activated,
the rangehood will continue to run for an additional
5 minutes to remove any odours that remain at the
completion of cooking.
During the 5 minute period the fan speed will gradually
reduce until the canopy turns itself OFF.
Note: If lamps are on when timer function is used, the
lamps will remain on.
When the timer function is activated the “ Timer ” LED
indicator will illuminate and the previously selected fan
speed LED indicator will turn off. To deactivate the timer,
press the timer button again or press a fan speed button
to resume normal operation.
Lamp – Press the ‘lamp’ symbol to turn the lamps ON,
The rst press will set the lamps to maximum intensity. The
second press will set the lamps to half intensity. The third
press will turn the lamps OFF. Lamps will now be ready to
be turned on again.
IDC Sydney
This drawing contains confidential information and is the property of Aktiebolaget Electrolux, Sydney, Australia
without whose permission it may not be copied, shown or handed to a third party or otherwise used, and it is to
be returned promptly upon request to Aktiebolaget Electrolux.
Icons Modified for Metal Letter
process -
Outdoor Hood
Electrolux
Monica Mazioun
11/11/10
100%
ART4624 C
Filter Latch
Lockpin
USING THE RANGEHOOD MAINTENANCE AND CLEANING
WARNING!
Before maintenance or cleaning is carried out,
the canopy rangehood should be disconnected
from the main power supply. Ensure that the
rangehood is switched off at the wall socket
and the plug removed.
WARNING!
External surfaces are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result is
achieved without damage.
Stainless Steel Surface
Clean stainless steel surfaces using non-abrasive cleaning
products that are specically for use on stainless steel.
To ensure best results also use an even pressure and
follow the grain of the stainless steel. Use of a soft cloth
reduces the risk of scratching. If the cloth is wet ensure
that a dry soft cloth is used to wipe down the the surface
and apply stainless steel protector to reduce the risk of
any surface rust appearing.
Cleaning grease filters
The lters can be cleaned by hand or dishwasher. After
cleaning ensure the lters are completely dry before
retting. Grease lters must be removed every four weeks
(maximum) for cleaning to reduce the risk of re.
• By hand: Soak in warm water and some washing up
liquid. For stubborn grease stains use a soft nylon brush
to help remove these stains.
• In a dishwasher: Ensure that placement of the lters is
made so as to not impede the function of the dishwasher
spray arm. Washing the lters in a dishwasher may
cause discolouration over time although it will not effect
their performance.Filters should be washed separately to
crockery and other kitchen utensils.
Removing filters
Remove lters by pulling down the latch to disengage the
lock pins. (Fig. A)
As lock pins are disengaged pull the lter slightly toward
you and then lift the lter up slightly to clear the bottom
lter support panel. (Fig. B)
Removing filter support panels
To remove bottom lter support panel, hold the panel at
each end and lift, then push the panel in. (see arrows in
Fig. C). This will disengage the panel support pins to allow
removal of the panel (Fig. C)
Do not use the rangehood without
filters installed.
Fig.A
Fig. B
Fig. C
1 2 3 4 5 6 7
1
Lock
2
Speed 1 (minimum)
3
Speed 2
4
Speed 3
5
Speed 4 (maximum)
6
Timer off
7
Lamp
1
Lift
2
Push in
3
Remove
Inner panels and trough
After each use the inner panels and trough should be
wiped clean with non-abrasive cleaning products to
prevent excessive build up of oils/grease.
WARNING!
Beware of edges
Bottom lter
support panel
Outer lter
Inner lter
1
2
3
Bottom lter
support panel
Komentáře k této Příručce