
8.8 Fitting and assembly
You can install the hob on a cabinet with
a special cutout.
R12
R5
15
50
1,5
485
+1
515
+1
685
+1
655
+1
The distance between opening of the cut
out and the bottom wall has to be at least
50 mm. The distance between the cutout
and a side wall should be at least 150
mm.
Installing the hob on a cabinet
1. Insert the hooks into the slots of
mounting kit.
2. Bond a seal stripe (one - component
silicone, type Dow Corning 7091 or
similar) along the 15 x 1.5 mm rabbet
mostly focusing on the outer edge.
3. Put the hob into the cutout.
4. Clean and standardize the silicone
along the perimeter of the hob with
scraper. For better results, apply the
perimeter and the remove it.
5. Clean the area around the hob with a
cloth and soapy water.
6. Screw the hooks from step 1. It is not
necessary to screw them to the
maximum. The position of the hooks
is arranged for a cooktop thickness of
40 / 50 mm.
7. If the thickness is 30 mm, use
supplied brackets.
The length of the brackets allow to
reach two hooks for a single bracket.
It is recommended to exclude the
rear centre hook. This does not affect
the quality of fastening. There is a
cartridge of transparent silicone (80
ml) provided for use in case of needs
for specific color.
CAUTION!
Install the appliance only on
a worktop with flat surface.
If you install the hob under a
hood, please see the
installation instructions of the
hood for the minimum
distance between the
appliances.
www.electrolux.com14
Komentáře k této Příručce