Electrolux EOG2102BOX Uživatelský manuál stáhnout pdf (Strana 20)

12.3 Oven injector replacement

1. Remove the bottom plate of the oven

cavity (A) to get access to the oven

burner (B).

AB

2. Release the screw (C), which keeps

the burner in position.

C

3. Carefully move the burner off the

injector support (D).

D

E

F

4. Slowly move it to the left side. Do not

apply force to the wire of the spark

plug connector (F) and to the

thermocouple conductor (E).

5. Release the burner injector (D) with a

7 mm socket spanner and replace it

with a different one, which is

necessary for the type of gas you

use.

Refer to “Technical data” chapter.

6. Assemble the burner in a reverse

sequence.

Replace the gas type sticker near the

gas supply ramp with the one related to

the new gas type.

The gas oven burner does not need any

primary gas regulation.

Make sure that the gas

supply pressure of the

appliance is in line with the

recommended values.

If the supply gas pressure is

changeable or different than

the necessary pressure, you

must fit an applicable

pressure adjuster on the gas

supply pipe.

12.4 Minimum level adjustment

of the oven burner

1. Disconnect the appliance from the

electricity.

2. Turn the knob for the gas control to

the minimum position and remove it.

3. Adjust the adjustment screw (A) with

a thin-bladed screwdriver.

A

www.electrolux.com20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře