Electrolux EHT70838K Uživatelský manuál stáhnout pdf (Strana 8)

8 electrolux

Hob Burners

To light a burner:

z Turn the relevant knob anticlockwise to

maximum position and push down the knob to

ignite.

z After lighting the flame, keep the knob pushed

down for about 5 seconds. This will allow the

"thermocouple" (Fig. 1 - lett. D) to be heated

and the safety device to be switched off,

otherwise the gas supply would be interrupted.

Then, check the flame is regular and adjust it

as required.

If you cannot light the flame even after several

attempts, check the "cap" (Fig. 1 - lett. A) and

“crown” (Fig. 1 - lett. B) are in the correct position.

To put the flame out, turn the knob to the symbol

In the absence of electricity, ignition can occur

without the electrical device; in this case approach

the burner with a flame, push the relevant knob

Operation

INSTALLATION

Any gas installation must be carried out by qualified personnel, and in

accordance with existing rules and regulations.

The relevant instructions are to be found in the second section of this manual.

Please, ensure that, once the hob is installed, it is easily accessible for the

engineer in the event of a breakdown.

The manufacturer will not accept liability, should the above instructions or any

of the other safety instructions incorporated in this book be ignored.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important

to remove any protective materials, which were

put on in the factory.

The symbols mean:

= no gas supply

= maximum gas supply

= minimum gas supply

)

A - Burner cap C - Ignition candle

B - Burner crown D - Thermocouple

Triple crown burner

Fig. 1

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Žádné komentáře

Electrolux EHT70838K Uživatelský manuál Strana 8