Electrolux EHD60150P Uživatelský manuál Strana 18

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 28
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 17
18 electrolux
What to do if
Problem Possible cause Remedy
The appliance cannot be
switched on or is not operating
More than 10 seconds have
passed since the appliance was
switched on
Switch the appliance on again.
The lock is switched on Switch off the lock (See the section
“Locking/unlocking the control pan-
el”)
The child safety device is
switched on
Deactivate child safety device (See
the section “Child safety device”)
Several sensor fields were
touched at the same time
Only touch one sensor field
Automatic switch off has been
triggered
Remove any objects (pan, cloths,
etc.) that are lying on the control pan-
el. Switch the appliance on again
Dirty control panel The sensor fields must be dry and fat-
free.
The residual heat indicator is not
displaying anything
The cooking zone was only on for
a short time and is therefore not
hot
If the cooking zone is supposed to be
hot, call the Customer Service De-
partment.
Repeated acoustic signal (6x),
appliance switches off
One or more sensor fields have
been covered for longer than 10
seconds
Uncover sensor field
Acoustic signal sounds when ap-
pliance is switched off
The control panel is wholly or
partly covered by objects.
Remove objects.
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
The On/Off sensor field has been
covered up, e.g. by a cloth
Do not place any objects on the con-
trol panel
Display is switching between two
heat settings
Power management is reducing
the power of this cooking zone
See the section “Switching the power
function on and off”
lights up Unsuitable cookware Use suitable cookware
No cookware on the cooking
zone
Place cookware on the cooking zone
The diameter of the bottom of
the cookware is too small for the
cooking zone
Move onto a smaller cooking zone
Use suitable cookware
lights up Overheating protection for the
cooking zone has been triggered
Switch off the cooking zone. Switch
the cooking zone on again
Automatic switch-off has been
triggered
Switch appliance off. Switch appli-
ance on again
and number are displayed Electronics fault
Disconnect the appliance from the elec-
trical supply for a few minutes (Take the
fuse out of the house’s wiring system)
If after switching on again, is dis-
played again, call the customer service
department
Zobrazit stránku 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Komentáře k této Příručce

Žádné komentáře