Electrolux EGT6142NOX Uživatelský manuál stáhnout pdf (Strana 13)

8.4 Adjustment of minimum level

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

bypass screw position (A).

A

5. If you change:

• from natural gas G20/G25 20/25

mbar to liquid gas, fully tighten the

bypass screw in.

• from liquid gas to natural gas

G20/G25 20/25 mbar, undo the

bypass screw approximately 1/4 of

a turn.

WARNING!

Make sure the flame does not

go out when you quickly turn

the knob from the maximum

position to the minimum

position.

8.5 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a

correct plug which can hold the load

that the rating plate rates. Make sure

that you install the plug in a correct

socket.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the

appliance is in connection with an

extension cable, an adapter or a

multiple connection. Make sure that the

ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

Make sure that you connect

the blue neutral cable to the

terminal with a letter "N" on it.

Connect the brown (or black)

phase cable to the terminal

which has a letter "L". Keep

the phase cable connected at

all times.

8.6 Connection cable

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H05V2V2-F T90.

Make sure that the cable section is

applicable to the voltage and the working

temperature. The yellow / green earth wire

must be approximately 2 cm longer than

the brown (or black) phase wire.

8.7 Building In

min.

55 mm

min.

650 mm

550 mm

470 mm

min.

450 mm

30 mm

ENGLISH

13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Komentáře k této Příručce

Žádné komentáře