Electrolux EBSL7EEV Uživatelský manuál stáhnout pdf (Strana 22)

11.3 Steam Cleaning

Remove as much dirt as possible

manually.

Clean the inner door glass with a soft cloth

with warm water and a cleaning agent.

Remove the shelf support to clean the

side walls.

CAUTION!

For a better performance you

should start the cleaning

function when the appliance

is cool. Check the residual

heat.

Always use the function after cooking with

steam.

When the function is active, the lamp is

off.

1. Put 400 ml of water mixed with 3

tablespoons of vinegar (without herbs)

directly into the steam generator.

2. In the menu activate the function:

Steam Cleaning.

The display shows the duration of the

function (33 minutes).

An acoustic signal sounds when the

programme is completed.

3. Touch a sensor field to deactivate the

signal.

4. Wipe the internal surface of the

appliance with a soft sponge.

5. Remove the remaining water from the

steam generator.

6. After cleaning keep the appliance door

open for approximately 1 hour. Wait

until the appliance is dry. To speed up

the drying you can heat up the

appliance with hot air at temperature

150 °C for approximately 15 minutes.

You can get maximum effects of the

cleaning function if you manually clean the

appliance immediately after the function

ends.

Use the function two times if the level of

dirt is high. Make sure that the appliance

is cool before you activate the second

cycle.

11.4 Decalcification of the

Steam generator

1. Put 250 ml of water mixed with 3

tablespoons of vinegar directly into the

steam generator.

2. In the menu choose: Assisted

Cleaning.

3. Activate the function: Decalcification.

The display shows the duration of the

function (15 minutes).

An acoustic signal sounds when the

programme is completed.

4. Touch a sensor field to deactivate the

signal.

5. Remove the remaining water from the

steam generator.

6. Keep the door open for approximately

1 hour to let the appliance dry fully. To

speed up the drying you can heat up

the appliance with hot air at

temperature 150 °C for approximately

15 minutes.

11.5 Removing and installing the

door

You can remove the door to clean it.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3. Close the door until it is at an angle of

approximately 45°.

www.electrolux.com22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Komentáře k této Příručce

Žádné komentáře