Electrolux E40PV100FS Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Větráky Electrolux E40PV100FS. Electrolux E40PV100FS User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Installation
INSTALLATION PLANNING
A qualified installer must complete the installation of this built-in appliance. Proper
installation is your responsibility.
Carefully check the location where the hood is to be installed. The hood should be
placed for convenient access. Make certain that electrical power can be provided
in the selected location.
Plan the installation so that all minimum clearances are met or exceeded.
Dimensions shown provide minimum clearances, unless otherwise noted.
Make certain that you have everything necessary to ensure a proper
installation before proceeding.
Zobrazit stránku 0
1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Installation

InstallationINSTALLATION PLANNINGA qualified installer must complete the installation of this built-in appliance. Proper installation is your responsib

Strany 2 - Installation

InstallationVERIFY PACKAGE CONTENTS Unpack hood and check contents.You should receive:1 - Hood1 - Decorative Flue Assembly1 - Support Frame 1 - Duct

Strany 3

InstallationINSTALLING THE DUCTWORK1 Decide where the ductwork will run between the hood and the outside. Figure 5.2 A straight, short duct run will

Strany 4

InstallationINSTALLING THE SUPPORT SYSTEM1 At hood location, install 2 x 4 cross framing between ceiling joists using dimensions shown in Figure 6.2

Strany 5

InstallationCONNECTING THE DECORATIVE FLUE1 Secure the upper flue to the upper support frame with the mounting screws (3.9 x 9.5mm).2 Insert the lowe

Strany 6

InstallationMOUNTING THE HOOD TO SUPPORT FRAME1 Insert four (4) bolts through the top of the hood from the inside.2 Use four (4) nuts and four (4) wa

Strany 7

InstallationCONNECTING THE DUCTWORK1 Use 8” round metal duct to connect the discharge collar on the hood to the ductwork above.2 Use duct tape to ma

Strany 8 - INSTALLING THE FILTER(S)

INSTALLING THE FILTER(S)1 To remove the grease filter, grip the latch and pull it down. This will disengage the filters from the hood. Tilt the filter d

Komentáře k této Příručce

Žádné komentáře